Individual fronts
Use a distinct line when any production detail changes.
Height, width, quantity, orientation, drilling, grain or edge intent can distinguish one front from another.
Drawer fronts
Prepare every drawer front as a measured, numbered component.
Create individual or repeated drawer fronts with finished dimensions, quantities, grain intent and visible edge requirements.
- Single
- individual fronts
- Repeat
- matching quantities
- Set
- coordinated references
The clear version
What this part of DIY Joinery is for.
Drawer fronts may look interchangeable, but small dimension, drilling and grain differences matter. The template keeps each distinct front identifiable before material and production work are added.
Drawer stacks
Reference fronts in their installed order.
A sequence such as D01-top, D01-middle and D01-bottom remains clearer than three anonymous rectangles.
Drilling
Treat handle and fixing holes as exact coordinates.
The current component template does not infer hole centres. Add specialist operations later only when datum and positions are confirmed.
Build a drawer set
Start at the top and preserve the visual sequence.
The same method works for kitchens, wardrobes, desks and freestanding furniture.
Name the stack
Use the cabinet and vertical position in every reference.
Measure each front
Do not assume equal heights when the existing design appears regular.
Record grain intent
Identify whether the pattern should continue through the complete stack.
Front information
Prepare the complete visible specification.
Board selection follows after the geometry is clear.
- 01Finished height and width
- 02Stack and position reference
- 03Quantity of identical fronts
- 04Grain direction or matched sequence
- 05Visible edge sides
- 06Handle and fixing coordinates if required
Useful detail
Common questions.
Can I use one quantity for identical drawer fronts?
Yes, when dimensions and every production requirement are identical.
Does the template calculate gaps between drawer fronts?
No. It records the finished front sizes you approve.
Can grain continue across a drawer stack?
Record the intended direction and sequence, then select a compatible grain-controlled board and complete the grain-matching workflow.
Prepare a drawer front
Start with its installed reference and finished size.
Duplicate the line when another front shares the complete specification.